Learn more on the official Danby Support



Installation


There are two methods that can be used to install the Danby Parcel Guard, depending on what installation location is available. Decide which option is best for your chosen location and follow the steps below.




A. Secured through the rear

  1. Use a power drill and a 1/4” drill bit to create
    holes in the marked locations on the back wall
    of the Danby Parcel Guard.
  2. Place the Danby Parcel Guard against the wall or
    structure that it will be secured to.
  3. Use a pen or pencil to mark the hole locations
    through the drilled holes.
  4. Move the Danby Parcel Guard out of the way and then
    use a power drill and a 1/4” drill bit to create
    guide holes for the bolts or screws, at least 2.5”
    deep for wood screws and at least 3.75” deep
    for concrete bolts.
  5. Replace the Danby Parcel Guard and insert the wood
    screws or concrete bolts with washers into the
    holes. Use a wrench to tighten the wood screw.
    Tighten the nut on the concrete bolts and the
    sleeves will expand to secure the bolt.

B. Secured through the bottom

  1. Remove the platform at the bottom of the Parcel
    Guard. Two holes are pre-drilled in the bottom
    of the box.
  2. Place the Danby Parcel Guard on the floor or structure
    that it will be secured to.
  3. Use a pen or pencil to mark the hole locations
    through the drilled holes.
  4. Move the Danby Parcel Guard out of the way and then
    use a power drill and a 1/4” drill bit to create
    guide holes for the bolts or screws, at least 2.5”
    deep for wood screws and at least 3.75” deep
    for concrete bolts.
  5. Replace the Danby Parcel Guard and insert the wood
    screws or concrete bolts with washers into the
    holes. Use a wrench to tighten the wood screw.
    Tighten the nut on the concrete bolts and the
    sleeves will expand to secure the bolt.